Reference Guide

488 | IPv4 Routing
www.dell.com | support.dell.com
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command History
Usage Information
When a static route (or a protocol route) overlaps with Management static route, the static route (or a
protocol route) is preferred over the Management Static route. Also, Management static routes and the
Management Connected prefix are not reflected in the hardware routing tables. Separate routing tables
are maintained for IPv4 and IPv6 management routes. This command manages both tables.
Related
Commands
show arp
z
Display the ARP table.
Syntax
show arp [vrf vrf name][interface interface | ip ip-address [mask] | macaddress mac-address
[mac-address mask]] [cpu {cp | rp1 | rp2}] [static | dynamic] [summary]
Parameters
ip-address mask
Enter an IP address (dotted decimal format) and mask (/prefix
format) of the destination subnet.
ipv6-address prefix-length
Enter an IPv6 address (x:x:x:x::x format) and mask (/prefix
format) of the destination subnet. Enter the IPv6 address in the
x:x:x:x::x format followed by the prefix length in the /x format.
Range: /0 to /128
Note: The :: notation specifies successive hexadecimal fields of
zeros.
forwarding-router-address
Enter an IP address (dotted decimal format) or an IPv6 address
(x:x:x:x::x format) of a forwarding router.
managementethernet Enter the keyword managementethernet for the Management
interface on the Primary RPM.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
Version
8.3.7.0
Introduced on the S4810.
interface ManagementEthernet Configure the Management port on the system (either the Primary or
Standby RPM).
duplex (Management) Set the mode of the Management interface.
speed (Management interface) Set the speed for the Management interface.
S6000
vrf name
Show only the ARP cache entries tied to the VRF process.
cpu (OPTIONAL) Enter the keyword cpu with one of the following keywords to
view ARP entries on that CPU:
•
cp - view ARP entries on the control processer.
•
rp1 - view ARP entries on Routing Processor 1.
•
rp2 - view ARP entries on Routing Processor 2.