Reference Guide

IPv4 Routing | 487
Parameters
Defaults
IP selection 5-tuples (source-ip dest-ip vlan protocol L4-source-port L4-dest-port)
Command Modes
CONFIGURATION
Command History
management route
z
Configure a static route that points to the Management interface or a forwarding router.
Syntax
management route {{ip-address mask | {ipv6-address prefix-length}}
{forwarding-router-address | managementethernet}
To remove a static route, use the no management route{{ip-address mask | {ipv6-address
prefix-length}}{forwarding-router-address | managementethernet} command.
{ip-selection|
ipv6-selection
[source-ip |
source-ipv6 |
source-port-id |
source-module-id |
dest-ip | dest-ipv6 |
dest-port-id |
dest-module-id |
protocol | vlan |
L4-source-port |
L4-dest-port ]
To use IPv4 key fields in hash computation, enter the keyword ip-selection
followed by one of the parameters. To use IPv6 key fields in hash computation,
enter the keyword
ipv6-selection followed by one of the parameters.
• source-ip—Use IPv4 src-ip field in hash calculation.
• source-ipv6—Use IPv6 src-ip field in hash calculation
• source-port-id—Use src-port-id field in hash calculation.
• source-module-id—Use src-module-id field in hash calculation.
• dest-ip—Use IPv4 dest-ip field in hash calculation.
• dest-ipv6—Use IPv6 dest-ip field in hash calculation
• dest-port-id—Use dest-port-id field in hash calculation.
• dest-module-id—Use dest-module-id field in hash calculation.
• protocol—Use IPv4 protocol field in hash calculation.
• vlan—Use vlan field in hash calculation.
• L4-source-port—Use IPv4 L4-source-port field in hash calculation.
• L4-dest-port—Use IPv4 L4-dest-port field in hash calculation.
mac [source-mac |
source-port-id |
source-module-id |
dest-mac |
dest-port-id |
dest-module-id | vlan
| ethertype |
source-dest-mac ]
To use MAC key fields in hash computation, enter the keyword mac followed by
one of the parameters:
• source-mac—Use source-mac field in hash calculation.
• source-port-id—Use src-port-id field in hash calculation.
• source-module-id—Use src-module-id field in hash calculation.
• dest-mac—Use dest-mac field in hash calculation.
• dest-port-id —Use dest-port-id field in hash calculation.
• dest-module-id—Use dest-module-id field in hash calculation.
• vlan—Use vlan field in hash calculation .
• ethertype—Use Ethertype field in hash calculation.
• source-dest-mac—Use SMAC and DMAC fields in hash calculation.
tunnel
[ipv4-over-ipv4 |
ipv4-over-gre-ipv4 |
mac-in-mac]}
To use tunnel key fields in hash computation, enter the keyword tunnel followed
by one of the parameters:
• ipv4-over-ipv4—Use ipv4-over-ipv4 field in hash calculation.
• ipv4-over-gre-ipv4—Use ipv4-over-gre-ipv4 field in hash calculation.
• mac-in-mac—Use mac-in-mac field in hash calculation.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
S6000