Reference Guide

IPv4 Routing | 485
ip source-route
z
Enable FTOS to forward IP packets with source route information in the header.
Syntax
ip source-route
To drop packets with source route information, enter no ip route-source.
Defaults
Enabled.
Command Modes
CONFIGURATION
Command History
ip unreachables
z
Enable the generation of Internet Control Message Protocol (ICMP) unreachable messages.
Syntax
ip unreachables
To disable the generation of ICMP messages, enter no ip unreachables.
Defaults
Disabled
Command Modes
INTERFACE
Command History
load-balance
z
By default for S-Series, FTOS uses an IP 4-tuple (IP SA, IP DA, Source Port, and Destination Port) to
distribute IP traffic over members of a Port Channel as well as equal-cost paths. To designate another
method to balance traffic over Port Channel members, use the load-balance command.
Syntax
load-balance {ip-selection [dest-ip | source-ip]} | {mac [dest-mac | source-dest-mac |
source-mac]} | {tcp-udp [enable]}
To return to the default setting (IP 4-tuple), use the no version of the command.
S6000
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
S6000
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
S6000