Reference Guide

IPv4 Routing | 483
Parameters
Defaults
No name servers are configured.
Command Modes
CONFIGURATION
Command History
Usage Information
FTOS does not support sending DNS queries over a VLAN. DNS queries are sent out all other
interfaces, including the Management port.
ip proxy-arp
z
Enable Proxy ARP on an interface.
Syntax
ip proxy-arp
To disable Proxy ARP, enter no ip proxy-arp.
Defaults
Enabled.
Command Modes
INTERFACE
Command History
Related
Commands
ip route
z
Assign a static route to the switch.
Syntax
ip route vrf {vrf instance} destination mask {ip-address | interface [ip-address]} [distance]
[permanent] [tag tag-value]
To delete a specific static route, use the no ip route destination mask {address | interface
[ip-address]} command.
To delete all routes matching a certain route, use the no ip route destination mask command.
Parameters
ip-address
Enter the IP address, in dotted decimal format, of the name server to be used.
ip-address2
...
ip-address6
(OPTIONAL) Enter up five more IP addresses, in dotted decimal format, of name servers
to be used.
Separate the IP addresses with a space.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
S6000
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
show ip interface Displays the interface routing status and configuration.
S6000
vrf name (OPTIONAL) Enter the keyword vrf followed by the VRF Instances name to tie the
static route to the VRF instance.
destination
Enter the IP address in dotted decimal format of the destination device.