Reference Guide

482 | IPv4 Routing
www.dell.com | support.dell.com
ip host
z
Assign a name and IP address to be used by the host-to-IP address mapping table.
Syntax
ip host name ip-address
To remove an IP host, use the no ip host name [ip-address] command.
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command History
ip max-frag-count
z
Set the maximum number of fragments allowed in one packet for packet re-assembly.
Syntax
ip max-frag-count count
To place no limit on the number of fragments allowed, enter no ip max-frag-count.
Parameters
Defaults
No limit is set on number of fragments allowed.
Command Modes
CONFIGURATION
Command History
Usage Information
To avoid Denial of Service (DOS) attacks, keep the number of fragments allowed for re-assembly low.
ip name-server
z
Enter up to 6 IP addresses of name servers. The order you enter the addresses determines the order of
their use.
Syntax
ip name-server ip-address [ip-address2...ip-address6]
To remove a name server, use the no ip name-server ip-address command.
S6000
name
Enter a text string to associate with one IP address.
ip-address
Enter an IP address, in dotted decimal format, to be mapped to the name.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
S6000
count
Enter a number for the number of fragments allowed for re-assembly.
Range: 2 to 256
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
S6000