Reference Guide

480 | IPv4 Routing
www.dell.com | support.dell.com
FTOS does not support sending DNS queries over a VLAN. DNS queries are sent out all other
interfaces, including the Management port.
To view current bindings, use the show hosts command.
Related
Commands
ip domain-name
z
Configure one domain name for the switch.
Syntax
ip domain-name name
To remove the domain name, enter no ip domain-name.
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command History
Usage Information
You can only configure one domain name with the ip domain-name command. To configure more than
one domain name, configure the ip domain-list command up to 6 times.
Use the following steps to enable dynamic resolution of hosts:
• specify a domain name server with the ip name-server command.
• enable DNS with the ip domain-lookup command.
To view current bindings, use the show hosts command.
Related
Commands
ip helper-address
z
Specify the address of a DHCP server so that DHCP broadcast messages can be forwarded when the
DHCP server is not on the same subnet as the client.
Syntax
ip helper-address ip-address | ipv6-address | default-vrf
To remove a DHCP server address, enter no ip helper-address.
ip name-server Specify a DNS server.
show hosts View current bindings.
S6000
name
Enter one domain name to be used to complete unqualified names (that is,
incomplete domain names that cannot be resolved).
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
ip domain-list Configure additional names.
S6000