Reference Guide

IPv4 Routing | 479
ip domain-list
z
Configure names to complete unqualified host names.
Syntax
ip domain-list name
To remove the name, use the no ip domain-list name command.
Parameters
Defaults
Disabled.
Command Modes
CONFIGURATION
Command History
Usage Information
Configure the ip domain-list command up to 6 times to configure a list of possible domain names.
If both the ip domain-name and ip domain-list commands are configured, the software will try to
resolve the name using the ip domain-name command. If the name is not resolved, the software goes
through the list of names configured with the ip domain-list command to find a match.
Use the following steps to enable dynamic resolution of hosts:
• specify a domain name server with the ip name-server command.
• enable DNS with the ip domain-lookup command.
To view current bindings, use the show hosts command. To view DNS related configuration, use the
show running-config resolve command.
Related
Commands
ip domain-lookup
z
Enable dynamic host-name to address resolution (that is, DNS).
Syntax
ip domain-lookup
To disable DNS lookup, use the no ip domain-lookup.
Defaults
Disabled.
Command Mode
CONFIGURATION
Command History
Usage Information
To fully enable DNS, also specify one or more domain name servers with the ip name-server
command.
S6000
name
Enter a domain name to be used to complete unqualified names (that is, incomplete
domain names that cannot be resolved).
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
ip domain-name Specify a DNS server.
S6000
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000