Reference Guide

IPv4 Routing | 473
Related
Commands
clear tcp statistics
z
Clear TCP counters.
Syntax
clear tcp statistics [all | cp | rp1 | rp2]
Parameters
Command Modes
EXEC Privilege
Command History
debug arp
z
View information on ARP transactions.
Syntax
debug arp [interface] [count value]
To stop debugging ARP transactions, enter no debug arp.
Parameters
Command Modes
EXEC Privilege
ip route Assign an IP route to the switch.
show ip route View the routing table.
show ip route summary View a summary of the routing table.
S6000
all Enter the keyword all to clear all TCP statistics maintained on all switch processors.
cp (OPTIONAL) Enter the cp to clear only statistics from the Control Processor.
rp1 (OPTIONAL) Enter the keyword rp1 to clear only the statistics from Route Processor 1.
rp2 (OPTIONAL) Enter the keyword rp2 to clear only the statistics from Route Processor 2.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
S6000
interface
(OPTIONAL) Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
gigabitethernet followed by
the slot/port information.
• For the Management interface, enter the keyword
managementethernet followed
by the slot/port information. The slot range is 0-1 and the port range is 0.
• For a Port Channel interface, enter the keyword
port-channel followed by a number:
S-Series Range: 1-128
• For a 10-Gigabit Ethernet interface, enter the keyword tengigabitethernet followed
by the slot/port information.
• For a VLAN, enter the keyword
vlan followed by a number from 1 to 4094.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the
slot/port information.
count value (OPTIONAL) Enter the keyword count followed by the count value.
Range: 1 to 65534