Reference Guide

468 | IPv4 Routing
www.dell.com | support.dell.com
• ip unreachables
• load-balance
• load-balance hg
• management route
• show arp
• show arp retries
• show hosts
• show ip cam stack-unit
• show ip fib stack-unit
• show ip flow
• show ip interface
• show ip management-route
• show ip protocols
• show ip route
• show ip route list
• show ip route summary
• show ip traffic
• show tcp statistics
arp
z
Use Address Resolution Protocol (ARP) to associate an IP address with a MAC address in the switch.
Syntax
arp vrf {vrf name} ip-address mac-address interface
To remove an ARP address, use the no arp ip-address command.
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
S6000
vrf name
Enter the VRF process identifier to tie the static route to the VRF process.
ip-address
Enter an IP address in dotted decimal format.
mac-address
Enter a MAC address in nnnn.nnnn.nnnn format.
interface
Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed
by the slot/port information.
• For the Management interface, enter the keyword
ManagementEthernet
followed by the slot/port information. The slot range is 0-1 and the port range is 0.
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
S-Series Range: 1-128
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the
slot/port information.