Reference Guide

Interfaces | 465
Figure 20-39. show interfaces port-channel brief Command Example
FTOS#sh int por 1 br
LAG Mode Status Uptime Ports
1 L2 up 00:00:08 Gi 3/0 (Up) *
Gi 3/1 (Down)
Gi 3/2 (Up)
FTOS#
Related
Commands
show port-channel-flow
s z
Display an egress port in a given port-channel flow.
Syntax
show port-channel-flow port-channel{number} incoming-interface {interface-type} {slot/port}
src-mac {MAC-Address} dest-mac {MAC-Address} vlan/ether-type {Vlan-Number/ether-type} src-ip
{IP-Address} dest-ip {IP-Address} protocol {tcp/udp/protocol number} src-port {Port} dest-port
{Port}
Parameters
Table 20-12. show interfaces port-channel brief Command Example Fields
Field Description
LAG Lists the port channel number.
Mode Lists the mode:
• L3 - for Layer 3
• L2 - for Layer 2
Status Displays the status of the port channel.
• down - if the port channel is disabled (shutdown)
• up - if the port channel is enabled (no shutdown)
Uptime Displays the age of the port channel in hours:minutes:seconds.
Ports Lists the interfaces assigned to this port channel.
(untitled)
Displays the status of the physical interfaces (
up or down).
In Layer 2 port channels, an * (asterisk) indicates which interface is the
primary port of the port channel. The primary port sends out interface
PDU.
In Layer 3 port channels, the primary port is not indicated.
show lacp Display the LACP matrix.
S6000
port-channel number
Enter the keyword port-channel followed by the number of the port
channel to display flow information/
incoming-interface interface
Enter the keyword incoming-interface followed by the interface
type and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a Forty Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.