Reference Guide

Interfaces | 463
show config
s z
Display the current configuration of the selected LAG.
Syntax
show config
Command Modes
INTERFACE PORTCHANNEL
Example
Figure 20-37. show config Command Sample Output for a Selected LAG
FTOS(conf-if-po-1)#show config
!
interface Port-channel 1
no ip address
shutdown
FTOS(conf-if-po-1)#
Command History
show interfaces port-channel
s z
Display information on configured Port Channel groups.
Syntax
show interfaces port-channel [channel-number] [brief]
Parameters
Command Modes
EXEC
EXEC Privilege
Command History
Example
Figure 20-38. show interfaces port-channel Command Example (EtherScale)
FTOS#show interfaces port-channel 20
Port-channel 20 is up, line protocol is up (Failover-group 1 is down)
Hardware address is 00:01:e8:01:46:fa
Port-channel is part of failover-group 1
Internet address is 1.1.120.1/24
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 2000 Mbit
Members in this channel: Gi 0/5 Gi 0/18
ARP type: ARPA, ARP timeout 04:00:00
S6000
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
Version
8.3.7.0
Introduced on the S4810.
S6000
channel-number
(OPTIONAL) Enter the number of the port channel to display information on
that port channel:
S-Series Range: 1-128
brief (OPTIONAL) Enter the keyword brief to display only the port channel
number, the state of the port channel, and the number of interfaces in the port
channel.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
Version
8.3.7.0
Introduced on the S4810.
Version 9.0.2.0 Introduced for S-Series; Modified to display LAG failover group status