Reference Guide

462 | Interfaces
www.dell.com | support.dell.com
minimum-links
s z
Configure the minimum number of links in a LAG (Port Channel) that must be in “oper up” status for
the LAG to be also in “oper up” status.
Syntax
minimum-links number
Parameters
Defaults
1
Command Modes
INTERFACE
Command History
Usage Information
If you use this command to configure the minimum number of links in a LAG that must be in “oper up”
status, then the LAG must have at least that number of “oper up” links before it can be declared as up.
For example, if the required minimum is four, and only three are up, then the LAG will be considered
down.
port-channel failover-group
s z
Access the PORT-CHANNEL FAILOVER-GROUP mode to configure a LAG failover group.
Syntax
port-channel failover-group
To remove all LAG failover groups, use the no port-channel failover-group command.
Defaults
No default values or behavior
Command Modes
CONFIGURATION
Command History
Usage Information
This feature groups two LAGs to work in tandem as a supergroup, so that, for example, if one LAG
goes down, the other LAG is taken down automatically, providing an alternate path to reroute traffic,
avoiding oversubscription on the other LAG. You can use both static and dynamic (LACP) LAGs to
configure failover groups. For details, see the Port Channel chapter in the FTOS Configuration Guide.
Related
Commands
S6000
number
Enter the number of links in a LAG that must be in “oper up” status.
Maximum supported number is 8.
Range: 1 to 8
Default: 1
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
Version
8.3.7.0
Introduced on the S4810.
S6000
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
Version
8.3.7.0
Introduced on the S4810.
group Group two LAGs in a supergroup (“fate-sharing group”).
show interfaces port-channel Display information on configured Port Channel groups.