Reference Guide

Interfaces | 461
interface port-channel
s z
Create a Port Channel interface, which is a link aggregation group containing up to eight physical
interfaces on S-Series.
Syntax
interface port-channel channel-number
To delete a Port Channel, use the no interface port-channel channel-number command.
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command History
Example
Figure 20-36. interface port-channel Command Example
FTOS(conf)#int port-channel 2
FTOS(conf-if-po-2)#
Usage Information
Port Channel interfaces are logical interfaces and can be either in Layer 2 mode (by using the
switchport command) or Layer 3 mode (by configuring an IP address). You can add a Port Channel in
Layer 2 mode to a VLAN.
The shutdown, description, and name commands are the only commands that you can configure on an
interface while it is a member of a Port Channel. To add a physical interface to a Port Channel, the
interface can only have the shutdown, description, and name commands configured. The Port
Channel’s configuration is applied to the interfaces within the Port Channel.
A Port Channel can contain both 100/1000 interfaces and GE interfaces. Based on the first interface
configured in the Port Channel and enabled, FTOS determines if the Port Channel uses 100 Mb/s or
1000 Mb/s as the common speed. Refer to channel-member for more information.
If the stack-unit is in a Jumbo mode chassis, then the mtu and ip mtu commands can also be
configured. The Link MTU and IP MTU values configured on the channel members must be greater
than the Link MTU and IP MTU values configured on the Port Channel interface.
Related
Commands
S6000
channel-number
Enter a number as the interface number.
S-Series Range: 1-128
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
Version
8.3.7.0
Introduced on the S4810.
Note: In a Jumbo-enabled system, all members of a Port Channel must be configured with the
same link MTU values and the same IP MTU values.
channel-member Add a physical interface to the LAG.
interface Configure a physical interface.
interface loopback Configure a Loopback interface.
interface null Configure a null interface.
interface vlan Configure a VLAN.
shutdown Disable/Enable the port channel.