Reference Guide

Interfaces | 459
• interface port-channel
• minimum-links
• port-channel failover-group
• show config
• show interfaces port-channel
• show port-channel-flow
channel-member
s z
Add an interface to the Port Channel, while in the INTERFACE PORTCHANNEL mode.
Syntax
channel-member interface
To delete an interface from a Port Channel, use the no channel-member interface command.
Parameters
Defaults
Not configured.
Command Modes
INTERFACE PORTCHANNEL
Command History
Usage Information
Use the interface port-channel command to access this command.
You cannot add an interface to a Port Channel if the interface contains an IP address in its
configuration. Only the shutdown, description, mtu, and ip name-server commands can be configured
on an interface if it is to be added to a Port Channel. The mtu and ip mtu commands are only available
when the chassis is in Jumbo mode.
Link MTU and IP MTU considerations for Port Channels are:
• All members must have the same link MTU value and the same IP MTU value.
Note: The FTOS implementation of LAG or Port Channel requires that you configure a LAG
on both switches manually. For information on FTOS Link Aggregation Control Protocol
(LACP) for dynamic LAGs, refer to Chapter 22, Link Aggregation Control Protocol (LACP).
For more information on configuring and using Port Channels, refer to the FTOS
Configuration Guide.
S6000
interface
Enter the following keywords and slot/port or number information:
• For a 100/1000 Ethernet interface, enter the keyword
GigabitEthernet followed by
the slot/port information.
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the
slot/port information.
• For a Ten Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a Forty Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the
slot/port information.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
Version
8.3.7.0
Introduced on the S4810.