Reference Guide

Interfaces | 455
Related
Commands
show range
s z
Display all interfaces configured using the interface range command.
Syntax
show range
Command Mode
INTERFACE RANGE (config-if-range)
Command History
Example
Figure 20-35. show range Command Example
FTOS(conf-if-range-so-2/0-1,fa-0/0)#show range
interface 2/0 - 1
interface fastethernet 0/0
FTOS(conf-if-range-so-2/0-1,fa-0/0)#
Related
Commands
shutdown
s z
Disable an interface.
Syntax
shutdown
To activate an interface, enter no shutdown.
Defaults
The interface is disabled.
Command Modes
INTERFACE
Command History
Usage Information
The shutdown command marks a physical interface as unavailable for traffic. To discover if an
interface is disabled, use the show ip interface brief command. Disabled interfaces are listed as down.
interface Configure a physical interface on the switch.
show ip interface Displays Layer 3 information about the interfaces.
show interfaces Display information on a specific physical interface or virtual interface.
show inventory (S-Series
and Z-Series)
Display the S-Series switch type, components (including media), FTOS version
including hardware identification numbers and configured protocols.
S6000
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
Version
8.3.7.0
Introduced on the S4810.
interface Configure a physical interface on the switch.
show ip interface Displays Layer 3 information about the interfaces.
show interfaces Display information on a specific physical interface or virtual interface.
S6000
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
Version
8.3.7.0
Introduced on the S4810.