Reference Guide

Interfaces | 451
Parameters
Command Modes
EXEC
EXEC Privilege
Command History
Usage
See the figure below for an example screenshot, and see the following table or a description of the
output fields.
For related commands, see the Related Commands section, below, and see the Debugging and
Diagnostics chapter for your platform at the end of this book.
Example
Figure 20-34. show interfaces transceiver Command Example
FTOS#show interfaces transceiver
SFP is present.
SFP 0 Serial Base ID fields
SFP 0 Id = 0x03
SFP 0 Ext Id = 0x04
SFP 0 Connector = 0x07
SFP 0 Transciever Code = 0x00 0x00 0x00 0x01 0x20 0x40 0x0c 0x05
SFP 0 Encoding = 0x01
SFP 0 BR Nominal = 0x15
SFP 0 Length(9um) Km = 0x00
SFP 0 Length(9um) 100m = 0x00
SFP 0 Length(50um) 10m = 0x1e
SFP 0 Length(62.5um) 10m = 0x0f
SFP 0 Length(Copper) 10m = 0x00
SFP 0 Vendor Rev = A
SFP 0 Laser Wavelength = 850 nm
SFP 0 CheckCodeBase = 0x66
SFP 0 Serial Extended ID fields
SFP 0 Options= 0x00 0x12
SFP 0 BR max= 0
SFP 0 BR min= 0
SFP 0 Vendor SN= P5N1ACE
SFP 0 Datecode = 040528
SFP 0 CheckCodeExt = 0x5b
SFP 1 Diagnostic Information
===================================
SFP 1 Rx Power measurement type = Average
===================================
SFP 1 Temp High Alarm threshold = 95.000C
SFP 1 Voltage High Alarm threshold = 3.900V
SFP 1 Bias High Alarm threshold = 17.000mA
SFP 1 TX Power High Alarm threshold = 0.631mW
SFP 1 RX Power High Alarm threshold = 1.259mW
SFP 1 Temp Low Alarm threshold = -25.000C
SFP 1 Voltage Low Alarm threshold = 2.700V
tengigabitethernet For a 10G interface, enter the keyword tengigabitethernet followed by the
slot/port information.
fortyGigE For a 40G interface, enter the keyword fortyGigE followed by the slot/port
information.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.7.0
Introduced on the S4810.
Version 7.7.1.0 Removed three fields in output: Vendor Name, Vendor OUI, Vendor PN
Version 9.0.2.0 Introduced on the S-Series