Reference Guide

448 | Interfaces
www.dell.com | support.dell.com
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
0 packets, 0 bytes, 0 underruns
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts, 0 Unicasts
0 throttles, 0 discarded, 0 collisions
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Time since last interface status change: 3w0d17h
GigabitEthernet 0/2 is down, line protocol is down
Hardware is FTOSEth, address is 00:01:e8:4c:f2:83
Current address is 00:01:e8:4c:f2:83
!-------------output truncated ----------------!
Related
Commands
show interfaces status
s z
Display a summary of interface information or specify a stack-unit slot and interface to display status
information on that specific interface only.
Syntax
show interfaces [interface | stack-unit slot-number] status
Parameters
Defaults
No default behavior or values
Command Modes
EXEC
EXEC Privilege
Command History
Example
Figure 20-32. show interfaces status Command Example
FTOS#show interfaces status
show hardware stack-unit Display data plane and management plane input/output statistics.
show interfaces Display information on a specific physical interface or virtual interface.
S6000
interface
(OPTIONAL) Enter one of the following keywords and slot/port or number
information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed
by the slot/port information.
stack-unit slot-number
(OPTIONAL) Enter the keyword stack-unit followed by the slot number.
Unit ID Range:
S4810: 0-11
Z9000: 0-7
S6000: 0-5
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
Version
8.3.7.0
Introduced on the S4810.