Reference Guide

Interfaces | 447
Related
Commands
show interfaces stack-unit
s z
Display information on all interfaces on a specific stack member.
Syntax
show interfaces stack-unit unit-number
Parameters
Command Modes
EXEC
EXEC Privilege
Command History
Example
Figure 20-31. show interfaces status Command Example
FTOS#show interfaces stack-unit 0
GigabitEthernet 0/1 is down, line protocol is down
Hardware is FTOSEth, address is 00:01:e8:4c:f2:82
Current address is 00:01:e8:4c:f2:82
Pluggable media not present
Interface index is 34129154
Internet address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed auto, Mode auto
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 3w0d17h
Queueing strategy: fifo
Input Statistics:
0 packets, 0 bytes
5144 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts
Table 20-7. show interfaces description Command Example Fields
Field Description
Interface Displays type of interface and associated slot and port number.
OK? Indicates if the hardware is functioning properly.
Status States whether the interface is enabled (up) or disabled (administratively down).
Protocol States whether IP is enabled (up) or disabled (down) on the interface.
Description Displays the description (if any) manually configured for the interface.
show interfaces Display information on a specific physical interface or virtual interface.
S6000
unit-number
Enter the stack member number
Unit ID range:
S4810: 0-11
Z9000: 0-7
S6000: 0-5
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
Version
8.3.7.0
Introduced on the S4810.