Reference Guide

444 | Interfaces
www.dell.com | support.dell.com
FTOS#
Usage Information
On the S-Series, the interface counter “over 1023-byte pkts” does not increment for packets in the
range 9216< x < 1023.
Related
Commands
show interfaces configured
s z
Display any interface with a non-default configuration.
Syntax
show interfaces configured
Command Modes
EXEC
EXEC Privilege
Command History
Example
Figure 20-28. show interfaces configured Command Output
FTOS#show interfaces configured
GigabitEthernet 13/18 is up, line protocol is up
Hardware is FTOSEth, address is 00:01:e8:05:f7:fc
Current address is 00:01:e8:05:f7:fc
Interface index is 474791997
Internet address is 1.1.1.1/24
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 1000 Mbit, Mode full duplex, Master
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interfaces" counters 00:12:42
Queueing strategy: fifo
Input Statistics:
10 packets, 10000 bytes
0 Vlans
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 10 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
1 packets, 64 bytes, 0 underruns
1 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
show interfaces configured Display any interface with a non-default configuration.
show interfaces stack-unit Display information on all interfaces on a specific stack-unit.
strict-priority queue Display information of either rate limiting or rate policing on the interface.
show interfaces switchport Display Layer 2 information about the interfaces.
show inventory (S-Series and
Z-Series)
Display the S-Series switch type, components (including media), FTOS
version including hardware identification numbers and configured
protocols.
show ip interface Display Layer 3 information about the interfaces.
show memory (S-Series) Display the stack-unit(s) status.
show range Display all interfaces configured using the interface range command.
S6000
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on Z9000
Version
8.3.7.0
Introduced on the S4810.