Reference Guide

44 | Control and Monitoring
www.dell.com | support.dell.com
banner exec
s z
Configure a message that is displayed when a user enters the EXEC mode.
Syntax
banner exec c line c
To delete a banner, enter no banner exec.
Parameters
Defaults
No banner is displayed.
Command Modes
CONFIGURATION
Command
History
Usage
Information
Optionally, use the banner exec command to create a text string that is displayed when the
user accesses the EXEC mode. The exec-banner command toggles that display
.
Example
FTOS(conf)#banner exec ?
LINE c banner-text c, where 'c' is a delimiting character
FTOS(conf)#banner exec %
Enter TEXT message. End with the character '%'.
This is the banner%
FTOS(conf)#end
FTOS#exit
4d21h5m: %RPM0-P:CP %SEC-5-LOGOUT: Exec session is terminated for user on line
console
This is the banner
FTOS con0 now available
ftp-server username ssh-peer-stack-unit
hostname telnet
ip ftp password telnet-peer-stack-unit
ip ftp source-interface terminal length
ip ftp username traceroute
ip telnet server enable undebug all
ip telnet source-interface virtual-ip
line write
S6000
c Enter the keywords banner exec, and then enter a character delineator,
represented here by the letter c, and press ENTER.
line Enter a text string for your banner message ending the message with your
delineator.
In the example below, the delineator is a percent character (%); the banner
message is “testing, testing”.
Version 9.0.2.0 Introduced on the S6000.
Version 9.0.0.0 Introduced on Z9000
Version 7.8.1.0 Introduced support on S-Series