Reference Guide

438 | Interfaces
www.dell.com | support.dell.com
show config (from INTERFACE RANGE mode)
s z
Display the bulk configured interfaces (interface range).
Syntax
show config
Command Modes
CONFIGURATION INTERFACE (conf-if-range)
Command History
Example
Figure 20-24. show config (Bulk Configuration) Command Example
FTOS(conf-if-range-te-0/0-1)#show config
!interface TenGigabitEthernet 0/0
no ip address
mtu 12000
switchport
no shutdown
!
interface TenGigabitEthernet 0/1
no ip address
mtu 12000
switchport
no shutdown
FTOS(conf-if-range-te-0/0-1)##
show interfaces
s z
Display information on a specific physical interface or virtual interface.
Syntax
show interfaces interface
Parameters
S6000
Version 9.0.2.0 Introduced on then S6000.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.2.1.0 Introduced on the S4810
S6000
interface
Enter one of the following keywords and slot/port or number information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet followed by the slot/port
information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by
the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port
information.
• For a Loopback interface, enter the keyword
loopback followed by a number from 0 to
16383.
• For the management interface on an RPM, enter the keyword
ManagementEthernet
followed by the slot/port information. The slot range is 0-1 and the port range is 0.
• For a Null interface, enter the keywords
null 0.
• For a port channel interface, enter the keyword
port-channel followed by a number:
S-Series Range: 1-128
• For a VLAN interface, enter the keyword vlan followed by a number from 1 to 4094.