Reference Guide

Control and Monitoring | 43
4
Control and Monitoring
Overview
This chapter contains the following commands to configure and monitor the system,
including Telnet, FTP, and TFTP as they apply to the following Dell Networking platforms:
s S-Series, z Z-Series, .
Commands
Note: Beginning in release 9.0.2.0, the end command was deprecated for the S6000,
Z9000. It was replaced by the enable optic-info-update interval command to update
information on temperature and power monitoring in the SNMP MIB.
banner exec motd-banner
banner login ping
banner motd reload
clear alarms send
clear command history service timestamps
clear line show alarms
configure show command-tree
debug cpu-traffic-stats show cpu-traffic-stats
debug ftpserver show debugging
disable show environment (S-Series)
do show inventory (S-Series and Z-Series)
enable show memory (S-Series)
enable optic-info-update interval show processes cpu (S-Series)
end show processes ipc flow-control
exec-timeout show processes memory (S-Series)
exit show software ifm
ftp-server enable show system (S-Series and Z-Series)
ftp-server topdir show tech-support (S-Series and Z-Series)
S6000