Reference Guide

Interfaces | 429
interface range macro name
s z
Run the interface-range macro to automatically configure the pre-defined range of interfaces.
Syntax
interface range macro name
Parameters
Defaults
This command has no default behavior or value
Command Modes
CONFIGURATION
Command History
Usage Information
Figure 20-14 runs the macro named test that was defined in Figure 20-13.
Example
Figure 20-14. interface-range macro Command Example
FTOS(config)#interface range macro test
FTOS(config-if-range-te-0/0-3,gi-5/0-47,gi-13/0-89)#
FTOS
Related
Commands
interface vlan
s z
Configure a VLAN. You can configure up to 4094 VLANs.
Syntax
interface vlan vlan-id
To delete a VLAN, use the no interface vlan vlan-id command.
Parameters
Defaults
Not configured, except for the Default VLAN, which is configured as VLAN 1.
Command Modes
CONFIGURATION
Command History
Example
Figure 20-15. interface vlan Command Example
FTOS(conf)#int vlan 3
FTOS(conf-if-vl-3)#
S6000
name
Enter the name of an existing macro.
Version 9.0.2.0 Introduced on then S6000.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.2.1.0 Introduced on the S4810
interface range Configure a range of command (bulk configuration)
interface range macro (define) Define a macro for an interface range (bulk configuration)
S6000
vlan-id
Enter a number as the VLAN Identifier.
Range: 1 to 4094.
Version 9.0.2.0 Introduced on then S6000.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.2.1.0 Introduced on the S-Series