Reference Guide

424 | Interfaces
www.dell.com | support.dell.com
Command History
Example
Figure 20-4. interface loopback Command Example
FTOS(conf)#interface loopback 1655
FTOS(conf-if-lo-1655)#
Related
Commands
interface ManagementEthernet
s z
Configure the Management port on the system.
Syntax
interface ManagementEthernet slot/port
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command History
Example
Figure 20-5. interface ManagementEthernet Command Example
FTOS(conf)#interface managementethernet 0/0
FTOS(conf-if-ma-0/0)#
Usage Information
You cannot delete a Management port.
The Management port is enabled by default (no shutdown). Use the ip address command to assign an
IP address to the Management port.
Related
Commands
Version 9.0.2.0 Introduced on then S6000.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.2.1.0 Introduced on the S-Series
interface Configure a physical interface.
interface null Configure a Null interface.
interface port-channel Configure a port channel.
interface vlan Configure a VLAN.
S6000
slot/port
Enter the keyword ManagementEthernet followed by slot number (0-5) and port
number zero (0).
Version 9.0.2.0 Introduced on then S6000.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.2.1.0 Introduced on the S4810
management route Configure a static route that points to the Management interface or a
forwarding router.
duplex (Management) Clear FIB entries on a specified stack-unit.
speed (Management interface) Clear FIB entries on a specified stack-unit.