Reference Guide

416 | Interfaces
www.dell.com | support.dell.com
• show interfaces
• show interfaces configured
• show interfaces dampening
• show interfaces description
• show interfaces stack-unit
• show interfaces status
• show interfaces switchport
• show interfaces transceiver
• show range
• shutdown
• speed (Management interface)
• stack-unit portmode
• switchport
• Port Channel Commands
clear counters
s z
Clear the counters used in the show interfaces commands for all VRRP groups, VLANs, and physical
interfaces, or selected ones.
Syntax
clear counters [interface] [vrrp [vrid] | learning-limit]
Parameters
Defaults
Without an interface specified, the command clears all interface counters.
Command Modes
EXEC Privilege
S6000
interface
(OPTIONAL) Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed
by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the
slot/port information.
• For a Loopback interface, enter the keyword
loopback followed by a number from
0 to 16383.
• For a port channel interface, enter the keyword
port-channel followed by the
number of the port channel:
S-Series Range: 1-128
• For the management interface on the RPM, enter the keyword
ManagementEthernet followed by slot/port information. The slot range is 0-1,
and the port range is 0.
• For a VLAN, enter the keyword
vlan followed by a number from 1 to 4094.
vrrp vrid
(OPTIONAL) Enter the keyword vrrp to clear statistics for all VRRP groups
configured. Enter a number from 1 to 255 as the
vrid.
learning-limit (OPTIONAL) Enter the keyword learning-limit to clear unknown source address (SA)
drop counters when MAC learning limit is configured on the interface.
Note: This option is not supported on the S-Series, as the MAC learning limit
is not supported