Reference Guide

412 | Internet Group Management Protocol (IGMP)
www.dell.com | support.dell.com
Parameters
Defaults
Not configured
Command Modes
INTERFACE VLAN—(conf-if-vl-n)
Command
History
Usage
Information
FTOS provides the capability of statically configuring interface to which a multicast router is attached.
To configure a static connection to the multicast router, enter the ip igmp snooping mrouter interface
command in the VLAN context. The interface to the router must be a part of the VLAN where you are
entering the command.
ip igmp snooping querier
z
Enable IGMP querier processing for the VLAN interface.
Syntax
ip igmp snooping querier
To disable IGMP querier processing for the VLAN interface, enter no ip igmp snooping querier
command.
Defaults
Not configured
Command Modes
INTERFACE VLAN—(conf-if-vl-n)
Command
History
Usage
Information
This command enables the IGMP switch to send General Queries periodically. This is useful when
there is no multicast router present in the VLAN because the multicast traffic does not need to be
routed. An IP address must be assigned to the VLAN interface for the switch to act as a querier for this
VLAN.
interface interface
Enter the following keywords and slot/port or number information:
• For an 100/1000 Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed
by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by
the slot/port information.
Version 9.0.2.0 Introduced on then S6000.
Version 8.3.11.1 Introduced on the Z9000.
Note: The S4810 supports up to 95 interfaces.
S6000
Version 9.0.2.0 Introduced on then S6000.
Version 8.3.11.1 Introduced on the Z9000.