Reference Guide

Internet Group Management Protocol (IGMP) | 407
Usage
Information
This command displays the IGMP database including configured entries for either all groups on all
interfaces, or all groups on specific interfaces, or specific groups on specific interfaces.
Example
Figure 19-1. show ip igmp groups Command Example
FTOS#show ip igmp groups
IGMP Connected Group Membership
Group Address Interface Uptime Expires Last Reporter
224.0.1.40 GigabitEthernet 13/6 09:45:23 00:02:08 10.87.7.5
FTOS#
show ip igmp interface
z
View information on the interfaces participating in IGMP.
Syntax
show ip igmp interface [interface]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Note: The S4810 supports up to 95 interfaces.
Table 19-1. show ip igmp groups Command Example Fields
Field Description
Group Address Lists the multicast address for the IGMP group.
Interface Lists the interface type, slot and port number.
Uptime Displays the amount of time the group has been operational.
Expires Displays the amount of time until the entry expires.
Last Reporter Displays the IP address of the last host to be a member of the IGMP group.
S6000
interface
(OPTIONAL) Enter the interface type and slot/port information:
• For a 100/1000 Ethernet interface, enter the keyword
gigabitethernet followed by the
slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
gigabitethernet followed by the
slot/port information.
• For a port-channel interface, enter the keyword
port-channel followed by the
port-channel number.
• For a Loopback interface, enter the keyword
loopback followed by a number from 0 to
16383.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by
the slot/port information.
• For a VLAN interface enter the keyword vlan followed by a number from 1 to 4094.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/
port information.
Version 9.0.2.0 Introduced on then S6000.
Version 8.3.11.1 Introduced on the Z9000.