Reference Guide

404 | Internet Group Management Protocol (IGMP)
www.dell.com | support.dell.com
Command
History
ip igmp query-max-resp-time
z
Set the maximum query response time advertised in general queries.
Syntax
ip igmp query-max-resp-time seconds
To return to the default values, enter no ip igmp query-max-resp-time.
Parameters
Defaults
10 seconds
Command Modes
INTERFACE
Command
History
ip igmp ssm-map
z
Use a statically configured list to translate (*,G) memberships to (S,G) memberships.
Syntax
ip igmp ssm-map std-access-list source-address
Undo this configuration, that is, remove SSM map (S,G) states and replace them with (*,G) states
using the command ip igmp ssm-map std-access-list source-address command.
Parameters
Command Modes
CONFIGURATION
Command
History
Version 9.0.2.0 Introduced on then S6000.
Version 8.3.11.1 Introduced on the Z9000.
Version 9.0.2.0 Introduced on S-Series in Interface VLAN mode only to enable that system to act as an
IGMP Proxy Querier.
S6000
seconds
Enter the number of seconds for the maximum response time.
Default: 10 seconds
Range: 1 to 25
Version 9.0.2.0 Introduced on then S6000.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.2.1.0 Introduced on the S-Series
S6000
std-access-list
Specify the standard IP access list that contains the mapping rules for multicast
groups.
source-address
Specify the multicast source address to which the groups are mapped.
Version 9.0.2.0 Introduced on then S6000.
Version 8.3.11.1 Introduced on the Z9000.