Reference Guide

402 | Internet Group Management Protocol (IGMP)
www.dell.com | support.dell.com
Parameters
Defaults
No default values or behavior
Command Modes
CONFIGURATION (conf-if-interface-slot/port)
Command
History
ip igmp immediate-leave
z
Enable IGMP immediate leave.
Syntax
ip igmp immediate-leave [group-list prefix-list-name]
To disable ip igmp immediate leave, use the no ip igmp immediate-leave command.
Parameters
Defaults
Not configured
Command Modes
INTERFACE
Command
History
Usage
Information
Querier normally send a certain number of group specific queries when a leave message is received, for
a group, prior to deleting a group from the membership database. There may be situations in which
immediate deletion of a group from the membership database is required. This command provides a
way to achieve the immediate deletion. In addition, this command provides a way to enable
immediate-leave processing for specified groups.
ip igmp last-member-query-interval
z
Change the last member query interval, which is the Max Response Time inserted into Group-Specific
Queries sent in response to Leave Group messages. This interval is also the interval between
Group-Specific Query messages.
Syntax
ip igmp last-member-query-interval milliseconds
To return to the default value, enter no ip igmp last-member-query-interval.
number
Enter the number of IGMP groups permitted to join in a second.
Range: 1 to 10000
Version 9.0.2.0 Introduced on then S6000.
Version 8.3.11.1 Introduced on the Z9000.
S6000
group-list prefix-list-name
Enter the keyword group-list followed by a string up to 16
characters long of the
prefix-list-name.
Version 9.0.2.0 Introduced on then S6000.
Version 8.3.11.1 Introduced on the Z9000.
S6000