Reference Guide

400 | Internet Group Management Protocol (IGMP)
www.dell.com | support.dell.com
• ip igmp query-max-resp-time
• ip igmp ssm-map
• ip igmp static-group
• ip igmp version
• show ip igmp groups
• show ip igmp interface
• show ip igmp ssm-map
clear ip igmp groups
z
Clear entries from the group cache table.
Syntax
clear ip igmp groups [group-address | interface]
Parameters
Command Modes
EXEC Privilege
Command
History
Usage
Information
IGMP commands accept only non-VLAN interfaces—specifying VLAN will not yield a results.
debug ip igmp
z
Enable debugging of IGMP packets.
Syntax
debug ip igmp [group address | interface]
To disable IGMP debugging, enter no debug ip igmp [group address | interface]. To disable all
debugging, enter undebug all.
S6000
group-address
(OPTIONAL) Enter the IP multicast group address in dotted decimal format.
interface
(OPTIONAL) Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
gigabitethernet followed
by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the
slot/port information.
• For a port-channel interface, enter the keyword
port-channel followed by
port-channel number.
Version 9.0.2.0 Introduced on then S6000.
Version 8.3.11.1 Introduced on the Z9000.
Note: The S6000 supports up to 95 interfaces.
S6000