Reference Guide

GARP VLAN Registration (GVRP) | 393
Leave Timer—Leave announces the willingness to de-register with other participants. Together with
the Join, Leave messages help GARP participants complete attribute reregistration and de-registration.
Leave Timer starts upon receipt of a leave message sent for de-registering some attribute information.
If a join message is not received before the leave time expires, the GARP application entity removes
the attribute information as requested.
Leave All Timer—The Leave All Timer starts when a GARP application entity starts. When this timer
expires, the entity sends a leave-all message so that other entities can re-register their attribute
information. Then, the leave-all time begins again.
Related
Commands
gvrp enable
s z
Enable GVRP on physical interfaces and LAGs.
Syntax
gvrp enable
To disable GVRP on the interface, use the no gvrp enable command.
Defaults
Disabled
Command Modes
CONFIGURATION-INTERFACE
Command
History
Related
Commands
gvrp registration
s z
Configure the GVRP register type.
Syntax
gvrp registration {fixed | normal | forbidden}
To return to the default, use the gvrp register normal command.
Parameters
Defaults
Default registration is normal
show garp timers Display the current GARP times
S6000
Version 9.0.2.0 Introduced on then S6000.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.2.1.0 Introduced on the S-Series
disable Globally disable GVRP.
S6000
fixed
Enter the keyword fixed followed by the VLAN range in a comma
separated VLAN ID set.
normal Enter the keyword normal followed by the VLAN range in a comma
separated VLAN ID set.
This is the default
forbidden Enter the keyword forbidden followed by the VLAN range in a comma
separated VLAN ID set.