Reference Guide

GARP VLAN Registration (GVRP) | 391
Command Modes
EXEC
Command
History
Related
Commands
debug gvrp
s z
Enable debugging on GVRP.
Syntax
debug gvrp {config | e vents | pdu}
To disable debugging, use the no debug gvrp {config | events | pdu} command.
Parameters
Defaults
Disabled
Command Modes
EXEC Privilege
Command
History
disable
s z
Globally disable GVRP.
Syntax
disable
To re-enable GVRP, use the no disable command.
Version 9.0.2.0 Introduced on then S6000.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.2.1.0 Introduced on the S-Series
show gvrp statistics Display the GVRP statistics
S6000
config Enter the keyword config to enable debugging on the GVRP configuration.
event
Enter the keyword event to enable debugging on the JOIN/LEAVE events.
pdu Enter the keyword pdu followed one of the following Interface keywords and slot/port
or number information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet followed by the
slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed
by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel followed by the
Port Channel number:
S-Series Range: 1-128
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the
slot/port information.
Version 9.0.2.0 Introduced on then S6000.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.2.1.0 Introduced on the S-Series
S6000