Reference Guide

Force10 Resilient Ring Protocol (FRRP) | 385
Defaults
No default values or behavior
Command Modes
CONFIGURATION (conf-frrp)
Command
History
Usage
Information
This command causes the Ring Manager to take ownership of these two ports after the configuration is
validated by the IFM. Ownership is relinquished for a port only when the interface does not play a part
in any control VLAN, that is, the interface does not belong to any ring.
Related
Commands
member-vlan
s z
Specify the member VLAN identification numbers.
Syntax
member-vlan {vlan-range}
To return to the default, use the no member-vlan [vlan-range] command.
Parameters
Defaults
No default values or behavior
Command Modes
CONFIGURATION (conf-frrp)
Command
History
mode
s z
Set the Master or Transit mode of the ring.
Syntax
mode {master | transit}
To reset the mode, use the no mode {master | transit} command.
Parameters
Defaults
Mode None
Version 9.0.2.0 Introduced on then S6000.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.2.1.0 Introduced on the S-Series
show frrp Display the Resilient Ring Protocol configuration information
S6000
vlan-range
Enter the member VLANs using comma separated VLAN IDs, a range of VLAN IDs, a
single VLAN ID, or a combination. For example:
Comma separated: 3, 4, 6
Range: 5-10
Combination: 3, 4, 5-10, 8
Version 9.0.2.0 Introduced on then S6000.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.2.1.0 Introduced on the S-Series
S6000
master Enter the keyword master to set the Ring node to Master mode.
transit Enter the keyword transit to set the Ring node to Transit mode.