Reference Guide

382 | Force10 Resilient Ring Protocol (FRRP)
www.dell.com | support.dell.com
clear frrp
s z
Clear the FRRP statistics counters.
Syntax
clear frrp [ring-id]
Parameters
Defaults
No default values or behavior
Command Modes
EXEC
Command
History
Example
Figure 17-1. clear frrp Command Examples
FTOS#clear frrp
Clear frrp statistics counter on all ring [confirm] yes
FTOS#clear frrp 4
Clear frrp statistics counter for ring 4 [confirm] yes
FTOS#
Usage
Information
Executing this command, without the optional ring-id, will clear statistics counters on all the available
rings. Force10 requires a command line confirmation before the command is executed. This commands
clears the following counters:
• hello Rx and Tx counters
• Topology change Rx and Tx counters
• The number of state change counters
Related
Commands
debug frrp
s z
Enable FRRP debugging.
Syntax
debug frrp {event | packet | detail} [ring-id] [count number]
To disable debugging, use the no debug frrp {event | packet | detail} {ring-id} [count number]
command.
S6000
ring-id
(Optional) Enter the ring identification number.
Range: 1 to 255
Version 9.0.2.0 Introduced on then S6000.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.2.1.0 Introduced on the S-Series
show frrp Display the Resilient Ring Protocol configuration
S6000
clears the frrp counters for all the available rings
confirmation required
clears the frrp counters on the specified ring
confirmation required