Reference Guide

362 | Dynamic Host Configuration Protocol (DHCP)
www.dell.com | support.dell.com
netbios-name-server
s z
Specify the NetBIOS Windows Internet Naming Service (WINS) name servers, in order of preference,
that are available to Microsoft Dynamic Host Configuration Protocol (DHCP) clients.
Syntax
netbios-name-server address [address2...address8]
Parameters
Command Mode
DHCP <POOL>
Default
None
Command History
netbios-node-type
s z
Specify the NetBIOS node type for a Microsoft DHCP client. Dell Networking recommends specifying
clients as hybrid.
Syntax
netbios-node-type type
Parameters
Command Mode
DHCP <POOL>
Default
Hybrid
Command History
network
s z
Specify the range of addresses in an address pool.
Syntax
network network /prefix-length
Parameters
S6000
address
Enter the address of the NETBIOS name server. You may enter up to 8, in order of
preference.
Version 9.0.2.0 Introduced on then S6000.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.2.1.0 Introduced on the S-Series
S6000
type
Enter the NETBIOS node type.
Broadcast: Enter the keyword b-node.
Hybrid: Enter the keyword h-node.
Mixed: Enter the keyword m-node.
Peer-to-peer: Enter the keyword p-node.
Version 9.0.2.0 Introduced on then S6000.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.2.1.0 Introduced on the S-Series
S6000
network/
prefix-length
Specify a range of addresses.
Prefix-length Range: 17-31