Reference Guide

358 | Dynamic Host Configuration Protocol (DHCP)
www.dell.com | support.dell.com
clear ip dhcp
s z
Reset DHCP counters.
Syntax
clear ip dhcp [binding {address} | conflict | server statistics]
Parameters
Command Mode
EXEC Privilege
Default
None
Command History
Usage Information
Entering <CR> after clear ip dhcp binding, clears all the IPs from the binding table.
debug ip dhcp server
s z
Display FTOS debugging messages for DHCP.
Syntax
debug ip dhcp server [events | packets]
Parameters
Command Mode
EXEC Privilege
Default
None
Command History
default-router
s z
Assign a default gateway to clients based on address pool.
Syntax
default-router address [address2...address8]
S6000
binding
Enter this keyword to delete all entries in the binding table.
address
Enter the IP address to clear the binding entry for a single IP address.
conflicts
Enter this keyword to delete all of the log entries created for IP address
conflicts.
server statistics
Enter this keyword to clear all the server counter information.
Version 9.0.2.0 Introduced on then S6000.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.2.1.0 Introduced on the S-Series
S6000
events
Enter this keyword to display DHCP state changes.
packet
Enter this keyword to display packet transmission/reception.
Version 9.0.2.0 Introduced on then S6000.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.2.1.0 Introduced on the S-Series
S6000