Reference Guide

350 | Debugging and Diagnostics
www.dell.com | support.dell.com
show hardware layer3
z
Display Layer 3 ACL or QoS data for the selected stack member and stack member port-pipe.
Syntax
show hardware layer3 {eg-acl | in-acl | qos} stack-unit id port-set 0-0
Parameters
Defaults
No default behavior
Command Modes
EXEC Privilege
Command History
Usage Information
The unit numbers given are internal port numbers. For a cross reference of the internal and user port
numbers, see the Z9000 Debugging and Diagnostics chapter in the FTOS Configuration Guide for the
Z9000 System.
show hardware stack-unit
z
Display the data plane or management plane input and output statistics of the designated component of
the designated stack member.
Syntax
stack-unit <id> {cpu data-plane statistics | cpu management statistics | [ drops [unit number
[port 1-104] | user-port 0-127] | fpga register | party-bus statistics | stack-port | ti-monitor | unit 0-1
{counters | details | port-stats [detail] | register}}
Parameters
S6000
eg-acl | in-acl | qos Enter either the keyword eg-acl, in-acl or qos to select between
ACL or QoS data.
stack-unit id
Enter the keyword stack-unit to select a stack ID.
Unit ID range:
Z9000: 0
port-set 0-0 Enter the keyword port-set with a port-pipe number — 0 or 0. The S25
models of the S-Series have only port-pipe 0.
Version 9.0.2.0 Introduced on S6000
Version 8.3.11.1 Introduced on Z9000
S6000
stack-unit stack-unit
{command-option}
Enter the keyword stack-unit to select a particular stack member and
then enter one of the following command options to display a
collection of data based on the option entered.
Z9000 range: 0 to 5
cpu i2c statistics Z9000 only: Enter the keywords cpu i2c statistics to display active i2c
address statistics.
cpu party-bus statistics Enter the keywords cpu party-bus statistics, to display the Management
plane input/output counter statistics of the pseudo party bus interface.
cpu sata-interface
statistics
Z9000 only: Enter the keywords cpu sata-interface statistics to
display the sata interface error counter statistics.
drops [unit 0-0 [port
1-104 | user-port 0-127]]
Enter the drops keyword to display internal drops on the selected stack
member. Option unit 0 followed by port 1-104 (in S6000) is based on
internal/hardware port number” and “option user-port 0-127 (in s6000) is to
see the drop using user port numbering convention.