Reference Guide

326 | Data Center Bridging (DCB)
www.dell.com | support.dell.com
Parameters
Defaults
none
Command Modes
EXEC PRIVILEGE
Command History
fcoe priority-bits
Configure the FCoE priority advertised for the FCoE protocol in application priority TLVs.
Syntax
fcoe priority-bits priority-bitmap
To remove the configured FCoE priority, use the no fcoe priority-bits command.
Parameters
Defaults
0x8
Command Modes
PROTOCOL LLDP
Command History
Usage Information
This command is available at the global level only.
iscsi priority-bits
Configure the iSCSI priority advertised for the iSCSI protocol in application priority TLVs.
Syntax
iscsi priority-bits priority-bitmap
To remove the configured iSCSI priority, use the no iscsi priority-bits command.
Parameters
{all |
auto-detect-timer |
config-exchng | fail |
mgmt | resource |
sem | tlv}
Enter the type of debugging, where:
•
all: enables all DCBX debugging operations.
•
auto-detect-timer: enables traces for DCBX auto-detect timers.
•
config-exchng: enables traces for DCBX configuration exchanges.
•
fail: enables traces for DCBX failures.
•
mgmt: enables traces for DCBX management frames.
•
resource: enables traces for DCBX system resource frames.
•
sem: enables traces for the DCBX state machine.
•
tlv: enables traces for DCBX TLVs.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module
S6000
priority-bitmap
Enter the priority-bitmap range.
Range: 1 to FF.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module
S6000
priority-bitmap
Enter the priority bitmap.
Range: 1 to FF.