Reference Guide

304 | Bare Metal Provisioning
www.dell.com | support.dell.com
stop jump-start
z
Stop the switch from reloading in Jumpstart (BMP) mode to prevent an infinite loop.
Syntax
stop jump-start
Defaults
None
Command Modes
EXEC Privilege
Command
History
Related
Commands
Usage
Information
Use the stop jump-start command on a switch running BMP 2.0 if the switch enters a loop
while reloading in jumpstart (BMP) mode; loop occurs when the switch is continuously trying
to contact a DHCP server and a DHCP server is not found. The stop jump-start command
stops the switch from connecting to the DHCP server. After the stop jump-start command
is used, the next default reload type will be a Normal reload. This will be indicated in the
show reload-type command.
S6000
Version 9.0.2.0 Introduced on the S6000.
version 9.0.0.0 Introduced on the Z9000.
Version 8.3.10.1 Introduced on the S4810.
reload-type Configure the reload mode as Normal or jumpstart.