Reference Guide

Bare Metal Provisioning | 303
Use the reload-type command in BMP 2.0 to toggle between Normal and Jumpstart (BMP)
auto-configuration modes. The reload settings for the auto-configuration mode that you
configure are stored in memory and retained for future reboots and BMP software upgrades.
You can enter the reload command at any time to reload the switch in the last configured
mode: Normal reload or Jumpstart (BMP) mode.
Related
Commands
show reload-type
z
Display the currently configured reload mode.
Syntax
show reload-type
Defaults
None
Command Modes
EXEC Privilege
Command
History
Usage
Information
Use the show reload-type command to check the currently configured auto-configuration
mode (Jumpstart or Normal reload) on a switch running BMP 2.0.
You can also use the show bootvar command to display the current reload mode for BMP
2.0 with the path of the FTOS image file retrieved from a DHCP server.
Example
FTOS#show reload-type
Reload-Type : normal-reload [Next boot : normal-reload]
config-scr-download : enable
dhcp-timeout : Infinity
user-defined-string :
Related
Commands
show reload-type Display the current reload mode (Normal or Jumpstart (BMP)
mode)
stop jump-start Stops the Jumpstart (BMP) process to prevent a loop if the DHCP
server is not found.
S6000
Version 9.0.2.0 Introduced on the S6000.
version 9.0.0.0 Introduced on the Z9000.
Version 8.3.10.1 Introduced on the S4810.
reload-type Configure the reload mode as Normal or BMP.