Reference Guide

Border Gateway Protocol | 291
Command Modes
CONFIGURATION (conf-ext-community-list)
Command
History
ip extcommunity-list
s z
Use this feature to enter the Extended Community-list mode.
Syntax
ip extcommunity-list word
To exit from this mode, use the exit command.
Parameters
Defaults
No defaults values or behavior
Command Modes
CONFIGURATION (conf-ext-community-list)
Usage
Information
This new mode will change the prompt. See the example below.
Example
Figure 9-29. Command Example: ip extcommunity-list
FTOS(conf)#ip extcommunity-list test
FTOS(conf-ext-community-list)#
Command
History
match extcommunity
s z
Use this feature to match an extended community in the Route Map mode.
Syntax
match extcommunity {extended community list name}
To change the match, use the no match extcommunity {extended community list name}
command.
Parameters
Defaults
No defaults values or behavior
Command Modes
ROUTE MAP (config-route-map)
Usage
Information
Like standard communities, extended communities can be used in route-map to match the attribute.
Version 9.0.2.0 Introduced on the S6000.
Version 9.0.0.0 Introduced on Z9000
Version 7.8.1.0 Introduced support on S-Series
S6000
word
Enter a community list name (maximum 16 characters).
Version 9.0.2.0 Introduced on the S6000.
Version 9.0.0.0 Introduced on Z9000
Version 7.8.1.0 Introduced support on S-Series
S6000
extended community list name
Enter the name of the extended community list.