Reference Guide

Border Gateway Protocol | 267
The show ip bgp community-list command without any parameters lists BGP routes matching the
Community List and the output is the same as for the show ip bgp command output.
Command
History
show ip bgp dampened-paths
s z
View BGP routes that are dampened (non-active).
Syntax
show ip bgp [ipv4 unicast] dampened-paths
Command Modes
EXEC
EXEC Privilege
Example
Figure 9-10. Command Example: show ip bgp dampened-paths
FTOS>show ip bgp damp
BGP table version is 210708, local router ID is 63.114.8.2
Status codes: s suppressed, d damped, h history, * valid, > best
Path source: I - internal, a - aggregate, c - confed-external, r -
redistributed, n - network
Origin codes: i - IGP, e - EGP, ? - incomplete
Network From Reuse Path
FTOS>
Table 9-5 defines the information displayed in Figure 9-10.
Table 9-4. show ip bgp community-list Command Example Fields
Field Description
Network Displays the destination network prefix of each BGP route.
Next Hop Displays the next hop address of the BGP router.
If 0.0.0.0 is listed in this column, then local routes exist in the routing table.
Metric Displays the BGP route’s metric, if assigned.
LocPrf Displays the BGP LOCAL_PREF attribute for the route.
Weight Displays the route’s weight
Path Lists all the ASs the route passed through to reach the destination network.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on the Z9000.
Version 7.8.1.0 Introduced support on S-Series
S6000
Table 9-5. show ip bgp dampened-paths Command Example
Field Description
Network Displays the network ID to which the route is dampened.
From Displays the IP address of the neighbor advertising the dampened route.
Reuse Displays the hour:minutes:seconds until the dampened route is available.
Path Lists all the ASs the dampened route passed through to reach the
destination network.