Reference Guide

260 | Border Gateway Protocol
www.dell.com | support.dell.com
Command
History
router bgp
s z
Enter ROUTER BGP mode to configure and enable BGP.
Syntax
router bgp as-number
To disable BGP, use the no router bgp as-number command.
Parameters
Defaults
Not enabled.
Command Modes
CONFIGURATION
Example
Figure 9-3. Command Example: router bgp
FTOS(conf)#router bgp 3
FTOS(conf-router_bgp)#
Command
History
Usage
Information
At least one interface must be in Layer 3 mode for the router bgp command to be accepted. If no
interfaces are enabled for Layer 3, an error message appears: % Error: No router id
configured
.
show capture bgp-pdu neighbor
s z
Display BGP packet capture information for an IPv4 address on the system.
Syntax
show capture bgp-pdu neighbor ipv4-address
Parameters
Command Modes
EXEC Privilege
Example
Figure 9-4. Command Example: show capture bgp-pdu neighbor
FTOS(conf-router_bgp)#show capture bgp-pdu neighbor 20.20.20.2
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on the Z9000.
Version 7.8.1.0 Introduced support on S-Series
Version 8.3.1.0 Introduced ability to substitute IGP cost for MED when a peer/peer-group
outbound route-map is set as internal.
S6000
as-number
Enter the AS number.
Range: 1 to 65535 (2-Byte) or 1-4294967295 (4-Byte)
or
0.1-65535.65535 (Dotted format)
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on the Z9000.
Version 7.8.1.0 Introduced support on S-Series
S6000
ipv4-address
Enter the IPv4 address (in dotted decimal format) of the BGP address to display
packet information for that address.