Reference Guide

Border Gateway Protocol | 257
Command
History
network
s z
Specify the networks for the BGP process and enter them in the BGP routing table.
Syntax
network ip-address mask [route-map map-name]
To remove a network, use the no network ip-address mask [route-map map-name] command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGP
Usage
Information
FTOS software resolves the network address configured by the network command with the routes in
the main routing table to ensure that the networks are reachable via non-BGP routes and non-default
routes.
Related
Commands
Command
History
network backdoor
s z
Specify this IGP route as the preferred route.
Syntax
network ip-address mask backdoor
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on the Z9000.
Version 7.8.1.0 Introduced support on S-Series
S6000
ip-address
Enter an IP address in dotted decimal format of the network.
mask
Enter the mask of the IP address in the slash prefix length format (for example, /24).
The mask appears in command outputs in dotted decimal format (A.B.C.D).
route-map
map-name
(OPTIONAL) Enter the keyword route-map followed by the name of an established route
map.
Only the following ROUTE-MAP mode commands are supported:
• match ip address
• set community
• set local-preference
• set metric
• set next-hop
• set origin
• set weight
If the route map is not configured, the default is deny (to drop all routes).
redistribute Redistribute routes into BGP.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on the Z9000.
Version 7.8.1.0 Introduced support on S-Series
S6000