Reference Guide

Border Gateway Protocol | 253
Defaults
Not configured and COMMUNITY attributes are not sent to neighbors.
Command Modes
ROUTER BGP
Usage
Information
To configure a COMMUNITY attribute, use the set community command in the ROUTE-MAP mode.
Command
History
neighbor shutdown
s z
Disable a BGP neighbor or peer group.
Syntax
neighbor {ip-address | peer-group-name} shutdown
To enable a disabled neighbor or peer group, use the neighbor {ip-address | peer-group-name} no
shutdown command.
Parameters
Defaults
Enabled (that is, BGP neighbors and peer groups are disabled.)
Command Modes
ROUTER BGP
Usage
Information
Peers that are enabled within a peer group are disabled when their peer group is disabled.
The neighbor shutdown command terminates all BGP sessions on the BGP neighbor or BGP peer
group. Use this command with caution as it terminates the specified BGP sessions. When a neighbor or
peer group is shutdown, use the show ip bgp summary command to confirm its status.
Related
Commands
Command
History
neighbor soft-reconfiguration inbound
s z
Enable soft-reconfiguration for BGP.
Syntax
neighbor {ip-address | peer-group-name} soft-reconfiguration inbound
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on the Z9000.
Version 7.8.1.0 Introduced support on S-Series
S6000
ip-address
Enter the IP address of the neighbor in dotted decimal format.
peer-group-name
Enter the name of the peer group to disable or enable all routers within the peer
group.
show ip bgp summary Displays the current BGP configuration.
show ip bgp neighbors Displays the current BGP neighbors.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on the Z9000.
Version 7.8.1.0 Introduced support on S-Series
S6000