Reference Guide

24 | CLI Basics
www.dell.com | support.dell.com
ROUTER RIP Mode
Use the ROUTER RIP mode to configure RIP, as described in Chapter 36, Router Information Protocol
(RIP).
To enter ROUTER RIP mode:
1. Verify that you are logged into the CONFIGURATION mode.
2. Enter the router rip command.The prompt changes to include (conf-router_rip).
You can switch to the INTERFACE mode by using the interface command or you can switch to the
ROUTER OSPF mode by using the router ospf command.
ROUTER BGP Mode
Use the ROUTER BGP mode to configure BGP, as described in Chapter 9, Border Gateway Protocol.
To enter ROUTER BGP mode:
1. Verify that you are logged into the CONFIGURATION mode.
2. Enter the router bgp as-number command.The prompt changes to include (conf-router_bgp).
You can return to the CONFIGURATION mode by entering the exit command.
Determining the Chassis Mode
The chassis mode in FTOS determines which hardware is being supported in chassis. The chassis mode
is programmed into an EEPROM on the backplane of the chassis and the change takes place only after
the chassis is rebooted. Configuring the appropriate chassis mode enables the system to use all the
ports on the card and recognize all software features.