Reference Guide

228 | Border Gateway Protocol
www.dell.com | support.dell.com
capture bgp-pdu neighbor
s z
Enable capture of an IPv4 BGP neighbor packet.
Syntax
capture bgp-pdu neighbor ipv4-address direction {both | rx | tx}
To disable capture of the IPv4 BGP neighbor packet, use the no capture bgp-pdu neighbor
ipv4-address command.
Parameters
Defaults
Not configured.
Command Modes
EXEC Privilege
Related
Commands
Command
History
capture bgp-pdu max-buffer-size
s z
Set the size of the BGP packet capture buffer. This buffer size pertains to both IPv4 and IPv6 addresses.
Syntax
capture bgp-pdu max-buffer-size 100-102400000
Parameters
Defaults
40960000 bytes.
Command Modes
EXEC Privilege
Related
Commands
Command
History
Version 7.2.1.0 Introduced
S6000
ipv4-address Enter the IPv4 address of the target BGP neighbor.
direction {both | rx | tx}
Enter the keyword direction and a direction— either rx for inbound,
tx for outbound, or both.
capture bgp-pdu max-buffer-size Specify a size for the capture buffer.
show capture bgp-pdu neighbor Display BGP packet capture information
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on the Z9000.
Version 7.8.1.0 Introduced support on S-Series
Version 7.5.1.0 Introduced
S6000
100-102400000
Enter a size for the capture buffer.
capture bgp-pdu neighbor Enable capture of an IPv4 BGP neighbor packet.
show capture bgp-pdu neighbor Display BGP packet capture information for an IPv6 address.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on the Z9000.