Reference Guide

Boot Command Line Interface (BCLI) | 199
BOOT_USER #
default-gateway
Assign an IP address as the default gateway for the system.
Syntax
[no] default-gateway ip-address
Parameters
Defaults
Not configured.
Command Modes
BOOT_USER
Command
History
Usage
Information
Use the show default-gateway command to view the current default gateway.
Related
Commands
ignore enable-password
Reload the system software without the enable password configured.
Syntax
ignore enable-password
Defaults
Not configured.
Command Modes
BOOT_USER
Command
History
Usage
Information
When you enter the reload command and the system reboots, you will not be prompted for a password
to enter the EXEC Privilege mode (normally you are required to enter the enable command.)
If your console or Telnet session expires after you used the ignore enable-password command,
you are prompted for an enable password when you re-establish the session.
Related
Commands
S6000
ip-address
Enter the IP address of the gateway router in dotted decimal format (A.B.C.D).
Version 9.0.2.0 Introduced on the S6000.
show default-gateway Change the primary, secondary or default boot image configuration.
S6000
Version 9.0.2.0 Introduced on the S6000.
reload
Exit from this mode and reload FTOS.