Reference Guide

Boot Command Line Interface (BCLI) | 197
To view the current boot configuration, use the show bootvar command.
Related
Commands
boot message
Use this command to enable/disable boot logs during reload.
Syntax
boot message on| off
Parameters
Note: By default, watchdog is disabled.
Command Modes
BOOT_USER
Command
History
Example
BOOT_USER #boot message
boot messages off
BOOT_USER #
boot zero
Erase the configured primary, secondary, or default boot image parameters. If you erase all three
parameters, the S6000 switch boots from its internal Flash.
Syntax
boot zero {primary | secondary | default}
Parameters
Defaults
Not configured.
Command Modes
BOOT_USER
Command
History
boot zero Remove the primary, secondary, or default boot image configuration.
show bootvar Display boot configuration information.
S6000
on
Enter the keyword on to turn on boot logs during reload.
off
Enter the keyword off to suppress the boot logs during reload.
Version 9.0.2.0 Introduced on the S6000.
S6000
primary Enter the keyword primary to configure the boot parameters used in the first attempt
to boot the system.
secondary Enter the keyword secondary to configure boot parameters used if the primary
operating system boot selection is not available.
default Enter the keyword default to configure boot parameters used if the secondary
operating system boot parameter selection is not available. You can configure this
option to any of the available type, for example flash/usb/ftp/tftp.
Version 9.0.2.0 Introduced on the S6000.