Reference Guide

Boot Command Line Interface (BCLI) | 195

Boot Command Line Interface (BCLI)

Overview

All commands in this chapter are in BOOT_USER mode. These commands are supported on the Dell

Networking platform.

To access BOOT_USER mode, first boot your Dell Networking platform.When you see the “Press

ESC to stop auto-boot”, press ESC to log into BCLI.

You enter BOOT_USER mode immediately, as indicated by the

BOOT_USER# prompt

Commands

• boot change

• boot message

• boot zero

• boot show net config retries

• boot write net config retries

• default-gateway

• ignore enable-password

• ignore startup-config

• interface management ethernet ip address

• reload

• show bootvar

• show default-gateway

• show interface management ethernet

• serial console

• show serial console baud rate

• etheraddr <macaddr>

• NVRAM erase

• watchdog <string>

Note: You cannot use the Tab key to complete commands in this mode.